lateral load การใช้

• :The ballast of the rocks resists the lateral load of the wire.
• We know the combination of vertical and lateral loads where we reach problems.
• Dead-end and other poles that support lateral loads have guy-wires to support them.
• The total frame behaves as a cantilever beam when subjected to lateral loads.
• Knee bracing is a common feature in timber framing to prevent racking under lateral loads.
• Steel diagonal brace frames extend from the ground to the roof to support the lateral load.
• Now walls might be made to withstand that kind of weight, but not that lateral load.
• Lateral load involves sideways force-the wind load on the entire area of an outside wall for example.
• The pole requires guys in only one direction to support the unbalanced lateral load of the power line in the other direction.
• The spandrel plates were located at each floor, transmitting shear stress between columns, allowing them to work together in resisting lateral loads.
• Increasing the vehicle's wheelbase ( length ) reduces longitudinal load transfer while increasing the vehicle's track ( width ) reduces lateral load transfer.
• The lateral loads begin to dominate the structural system and take on increasing importance in the overall building system when the building height increases.
• In his autobiography, Lauda described the car as being unpleasant to drive due to the lateral loads and reliance on aerodynamics over driver skill.
• High masonry structures require stabilisation against lateral loads from buttresses ( as with the flying buttresses seen in many European medieval churches ) or from windposts.
• The very low resistance to lateral loads of these structures explains why almost all the buildings in 莂ld1
  ran collapsed in the earthquake, causing most of the deaths.
• The holdowns provide uplift resistance against the overturning moment imposed on the wall due to " in-plane " lateral load applied at the top of the wall.
• Large water tanks at the tops of buildings could act as mass dampers to counteract any swaying from extreme lateral loads and as reservoirs for deluging fires.
• Another innovation that Fazlur Khan developed was the concept of X-bracing, which reduced the lateral load on the building by transferring the load into the exterior columns.
• This means that the lateral load transfer distribution, or the amount of load that is transferred across the front axle versus the rear while cornering, is rather rear biased.
• This exterior framing is designed sufficiently strong to resist all lateral loads on the building, thereby allowing the interior of the building to be simply framed for gravity loads.